My Binding Standard APC45 Programmable Manuel d'instructions télécharger pdf (Page 42)

34

4-1 Knife Lower Limit Adjustment

Adjust the lower limit.

- Insert the accessory driver into the adjusting

hole and rotate the shaft to adjust the lower

limit.

- 1/6 rotation of the knife height adjust-

ing screws lifts/lowers the knife about

0.6 mm (0.024"). Excessive cutting

depth may damage the machine.

Maximum cutting depth is 0.5 mm

(0.019").

- The standard length shown in the fig-

ure in the previous page is 399 mm

(15.71"). Adjust so that this length will

be 397 mm to 400 mm (15.63" to

15.74").

Fasten two lock nuts.

Close the lower cover.

Turn on the power switch.

Perform the test cutting.

- If the sheet still remains uncut, repeat the

steps through .

Adjusting Hole

Accessory

Driver

Lower

Lift

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 53 54

Commentaires sur ces manuels

Pas de commentaire