My Binding Standard APC45 Programmable Manuel d'instructions télécharger pdf (Page 46)

Cutting Stick Replacement Replacement and Adjustment

4-3 Cutting Stick Replacement

When the groove of the cutting stick

becomes deep, the bottom sheet may

remain uncut, or torn. In these cases,

replace the cutting stick.

Turn off the power switch.

Lift the cutting stick.

- Insert a screwdriver under the cutting stick

from the right and left groove, and lift it.

Remove the cutting stick.

- Lift the cutting stick, insert a screwdriver under

the cutting stick and slide it. The cutting stick

can be removed easily.

Clean the groove.

- In the groove for the cutting stick, paper chips

and paper dust remain. Remove them com-

pletely.

Insert a new cutting stick.

- Each cutting stick can be used up to eight

times - four faces and two surfaces per face.

Insert the unused surface of the cutting stick

face up.

WARNING

A single operator must replace the cutting

stick.

Wear gloves and be careful to keep your

hands away from the knife. Otherwise,

sharp knife can cause severe personal

injury.

Groove

Cutting Stick

Two Lines

with One Face

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 52 53 54

Pas de commentaire

My Binding Standard APC45 Programmable Manuel d'instructions Page 46